Product Description
Description
DC Audio m3 Level 2 Subwoofer
Sizes Available: 10 & 12 Inch Models
Ohms Available: D2 & D4 Models
Power Handling: 600 Watts RMS 1200 Watts Peak
With more power handling than before, the Level 2 is back and better than ever!
This sub has everything you need in a daily driver except the cost. This is one of our greatest accomplishments.
It starts out with a double stacked FEA optimized motor. A chrome top plate and T yoke to keep it looking good. It has 22 mm of X-Max, progressive spider, 2.5" voice coil, cast basket and push terminals.
This sub works great in sealed or ported enclosures.
Key Features
- Extremely rigid non-pressed paper cone assembly
- Multilayered polymer wide roll foam surround
- Polypropylene dust cover with DC logo
- Dual 8" OD flat linear roll spiders
- Heavy duty interweaved tinsel lead wire sewn to the spider
- Cast aluminum black frame
- FEA analyzed and optimized motor assembly - Fully CNC machined
- Rubber mounting gasket
- Rubber Motor Boot
- Chrome spring loaded push terminals
- 2.5” Hi-temp copper voice coil wound on black anodized voice coil former
- Rubber magnet cover
M3 Level 2 Subwoofers | 10" | 12" |
---|---|---|
Mounting Depth | 5.5" | 6.1" |
Mounting Hole Diameter | 9.35" | 11.00" |
Outside Driver Diameter | 11" | 12.5" |
VC Diameter | 2.5" | 2.5" |
Displacement | .12 ft | .14ft |
Power Handling rms/peak | 600/1200 | 600/1200 |
Ohm Options | d2/d4 | d2/d4 |
Sd | 324 cm | 481 cm |
Vas | 13.89 L | 30.6 L |
Cms | 0.095 Mm/n | 0.095 Mm/n |
Mms | 210 g | 245 g |
Fs | 35.6 Hz | 33 Hz |
Bl | 24 N/A | 24 N/A |
Re | 7.2 Ohm | 7.2 Ohm |
Le | 7 mH | 7 mH |
Qms | 8.96 | 8.46 |
Qes | 0.592 | 0.639 |
Qts | 0.555 | 0.594 |
Xmax | 22mm | 22mm |
Ref SPL @1 watt | 82.1 db | 84.2 db |
Suggest Sealed Box | .5 ft | .75 ft |
Suggested Ported Box | 1.0 ft | 1.25 ft |
Other Details
LENGTH OF WARRANTY DC Audio Products are covered by warranty for 1 year from date of purchase on parts and labor. This applies to the original purchaser only. Warranties are non-transferable. DETAILS OF WARRANTY From the date of original purchase and for the respective period, specified above. DC Audio agrees to repair or replace all DC Audio products, which are defective in material and/or workmanship. This warranty is not transferable and applies only to the original purchaser of the product. No Exceptions. It is DC Audio’s right to decide if a product will be repaired or replaced. All returns must be sent with an RA # on the outside of the box. Any and all products sent without a RA will be refused. An RA # can be obtained by calling DC Audio and requesting the number. Warranty claims must be accompanied by the original invoice to validate the warranty service. EXCLUSIONS This warranty does not apply with respect to the following: DC Audio’s warranty does not cover burned/open voice coils or lead wires, ripped surrounds or folded cones. These are all immediate signs of abuse/over powering. It does not cover products driven over their mechanical limits. Defects or damage caused by accident, fire, flood, and lightning or other acts of God. Defects or damage caused by abuse, misuse, or negligence. Products with voice coils that have failed due to excessive power levels or clipping, i.e. burned or open coils or lead wires. Damage caused during shipping or handling. These claims are made with the Freight Company. Accessories or anything else attached to or to be used with DC Audio products. Products that have their serial numbers removed or altered. Packing materials i.e. card board boxes, foam inserts, corners, peanuts, etc. Adjustments or alterations required for any reason. Items subject to fatigue through normal wear and use. Product, which has been altered or repaired by anyone other than DC Audio. RE-CONES All speakers, loudspeakers, subwoofers that have been re-coned by DC Audio will continue under warranty until the full 1 year warranty has expired. Any re-cone not performed at DC Audio by an authorized DC Audio worker is not covered under warranty. The end consumer accepts the responsibility and liability of knowing this speaker, loudspeaker, subwoofer no longer falls under DC Audio’s warranty program when the re-cones they purchased and/or the labor was performed by the end consumer. Amplifiers Amplifiers will not be covered under warranty if ran below their rated ohm load or if underpowered in any way. DC Audio has a "Recommended for Installation" section on each amplifiers web page. These need to be followed in order to ensure the amplifier will operate properly. Failure to do so can decrease the life of the amplifier and void your warranty.Product Videos
Custom Field
Product Reviews
2 Reviews Hide Reviews Show Reviews
-
Superb Sound Quality
It digs super deep and sounds really clean. I have it on 500 watts and the box is a little bigger than suggested at 1.4 after all displacements, This is my living rooms active subwoofer and it was an excellent choice.
-
Pricey but worth it
Never ran any of DC Audio products but was wanting a decent subwoofer that would work well in a small box so I didn't lose alot of trunk space. These Level 2 12s fit the bill. They really impress me to be in ported box with around 1.28 cu ft each and Incriminator Audio 10.1 amp running them they work and sound awesome for my daily use. I figure with the setup I have they're probably getting at least 500w each and they perform very well with that. They're punchy and like to dig low actually lower than they can so for me subsonic filter was definitely a must. But after tweaking that all is good. They sound like they're in bigger box. I'm still breaking them in for a little bit but I can tell they're going to be fine the way I'm running them. Build quality on these are top notch. I'm gonna run these and if all goes well I my try the Level 3. Like I said DC is pricey so its something to think about.