SMD IM-SG Car Audio Impedance Ohm Meter & Signal Generator

Some uses of the D’Amore Engineering / SMD IM-SG (Impedance Meter / Signal Generator).Obtain a driver's T/S Parameters*Determine speaker crossover set pointsFind tuning frequency of passive radiatorFind tuning frequency of ported...

SMD DD-1+ Distortion Detector Plus

The purpose of this tool is to enable the installer to set the gain of an audio amplifier to match the source unit’s output level, accurately and quickly. It can also be useful for detecting distortion in the audio signal caused by poorly designed...

SMD Combo Pack VM-1 Volt Meter, OM-1 Output Meter & TM-1 Temp Sensor Fan Controller

Product Spec VM-1: Input Range: 6v - 20.2v Voltage Reading Range: 12.6v - 20.2v Accuracy +/- 0.20v due to nature of bar graph 100% Analog circuitry allows for near instantaneous voltage accuracy versus a traditional digital voltage meter Response...

SMD TM-1 LED Amplifier Temperature Meter Fan Controller

Product Spec: 3 speed fan drive system (PWM) Operating voltage range for power supply 8v-22vdc Display range 30 - 220 F Fan set point range 40 - 200 F Maximum fan load 5 amps DC 2.75" x 2.75" x 0.6" depth

SMD Combo Pack VM-1 Volt Meter and OM-1 Output Meter

Product Spec VM-1: Input Range: 6v - 20.2v Voltage Reading Range: 12.6v - 20.2v Accuracy +/- 0.20v due to nature of bar graph 100% Analog circuitry allows for near instantaneous voltage accuracy versus a traditional digital voltage meter Response...

SMD (2) OM-1 LED Output Meter Combo

SMD (2) OM-1 COMBO Package Amplifier Output Meter - OM-1 Output MeterMonitor the Output of your Amplifier.  Calibrate with our DD-1 to know when you are reaching clipping.Some might consider the OM-1 to be over-built; we think it is just right. Some...

SMD DD-1 AND CC-1 Combo Pack

The purpose and benefit of the D’Amore Engineering / SMD Distortion Detector. The purpose of this tool is to enable the installer to set the gain of an audio amplifier to match the source unit’s output level, accurately and quickly...

SMD OM-1 LED Amplifier Output Meter

SMD OM-1 LED Amplifier Output MeterMonitor the Output of your Amplifier.  Calibrate with our DD-1 to know when you are reaching clipping.Some might consider the OM-1 to be over-built; we think it is just right. Some features of the design are:Mil...

SMD CROSSOVER CALIBRATOR CC-1

The purpose and benefit of the D’Amore Engineering / SMD Crossover Calibrator. Most modern car audio amplifiers have a built in crossover on the side. Usually, it will start at 30hz and have a huge gap, all the way up to...

SMD VM-1 Volt Meter 12v

Monitor the condition of your battery and charging system.  Some might consider the VM-1 to be over-built; we think it is just right. Some features of the design are: •White LED Backlight •Mil spec FR4 circuit board •Regulated...

Steve Meade SMD DD-1

The purpose and benefit of the D’Amore Engineering / SMD Distortion Detector. The purpose of this tool is to enable the installer to set the gain of an audio amplifier to match the source unit’s output level, accurately and...

Sky High Car Audio 4ga to 8ga Amp Inputs

Clean up any car audio install with the Sky High Car Audio Machined Amp Inputs! 4 gauge to 8 gauge reducer  Made here locally in the USA  Sold as a pair