Product Description
This listing is for a B-Stock product. B-Stock refers to an item that could have been purchased and returned in not new condition, old inventory, cosmetically damaged in shipping or warranty repaired. These items are sold as is and offer no refunds. All items are tested and verified to be fully functional, with only cosmetic issues. Cosmetic issues may include: scratches, scuffs, dents or cosmetically broken parts.
We offer a 5-Day plug and play warranty starting from day of delivery. Image in listing may not be exact item you are buying but for reference of other B-Stock item or new item.
The 5.0kw competition series amplifier is a 5,000 watt mono block. It is capable of running up to 18 volts
for up to 7,300 watts. It is a linkable amp and designed to run a 1 ohm per amp or 2 ohms when strapped.
It comes with a bass knob and a clipping indicator. For power inputs it will accept dual 0 awg for power
and dual 0 awg for ground.
Key Features
• 1 ohm stable
• Variable low pass filter
• Variable subsonic filter
• Variable bass boost
• Wired remote control
• Clipping indicator
• Dual 0 awg power and ground inputs (both must be used)
We recommend for installation
• 1 upgraded battery under the hood
• 1 extra 800ci battery in the rear
• Minimum of two 0 awg ran from the front battery to the rear battery
• Both 0 awg power and ground inputs on amp must have 0 awg ran to them for a total of 4 runs into the amp
• Upgraded aftermarket alternator
• Dash mounted voltage meter
Features | Voltage | 5.0kw | |
Output Power (RMS) | 4 ohm | 14.4V | 900W x 1 |
2 ohm | 2,300W x 1 | ||
1 ohm | 5,000W x 1 | ||
1 ohm | 16V | 6,000W x 1 | |
1 ohm | 18V | 7,300W x 1 | |
Input Sensitivity | 6V~0.2V | ||
Low Pass Filter | Switchable | ||
( @ 24 dB Slope) | Variable | Hz | 35~250 |
Subsonic Filter | Switchable | ||
( @ 24dB slope ) | Variable | Hz | 10~50 |
Bass Boost | Variable | dB | 0-9dB |
Frequency Response | Hz | 15-270 | |
Signal to Noise Ratio | dB | 100 | |
Damping factor | 150< | ||
Efficiency @ 4ohm | % | Over 90% | |
THD @ 4ohms | Less than 0.1% | ||
Fuse Rating | 500 Amps | ||
Linked Fuse Rating | 1000 Amps | ||
Indicator | Power | Yes | |
Protection | Yes | ||
Clip | Yes | ||
Speaker & Power terminal | Mold Type | Yes | |
Power | Gauge | 0Ga | |
Heatsink Length | inch/mm | 25.59"/650mm | |
Heatsink Width | inch/mm | 9.38"/66mm | |
Heatsink Height | inch/mm | 2.35"/59.6mm |